Quotations are hereby invited for the following: Repair MV cables over summer breakdowns. The scope of work: Terminations: 1. The cable will be isolated by municipality officials, tested to identify the position of the fault and earth from all source of supply, 2. Disconnect the affected termination, cut, clean, prepare for terminating, 3. Do insulation and resistance tests on the cable with a prepared termination before you complete the termination and after the termination is completed, record and submit result to project manager, 4. Where there is not enough cable slack to do a termination, a piece will be added including a joint to complete one termination and you will also need to excavate for work to be up to the correct standard and the termination must be done according to an approved standard, 5. The termination must be lugged and connected at completion, 6. When disconnecting the cable, phase rotation must be taken into consideration, marked before disconnecting and when connecting the cable, 7. Should the termination fail before guaranteed time, the service provider have to repair at own cost and material, Cable joints: 1. Safety before working will be ensured by municipality officials, 2. Service provider will need to excavate to expose the faulty cable, after municipality testing official has located the fault on the cable, 3. The joint must be made on the dry surface, the distance between the joints must not be less than 5 meters if there a two joints on one cable, 4. Excavation must be carried out with caution as there might be live cables around the faulty cable, 5. Clean, cut, prepare the cable for joining, insulation and resistance test the cable before completing the joint, test the piece to be insert, then test the cable after joining is completed. Record the results and submit them to project manager, 6. Ensure that phase rotation is correct when doing cable joints, 7. Cable joints must be done according to an approved standard, 8. Should the joint fail before guaranteed time, the service provider has to repair at own cost and material, 9. The service provider must refill have completing the joints. (Tender №95796003)